Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX 501 setting factory default

What is the command for setting a PIX 501 to factory default settings, Version 6.2(2)?

The following command does not work.

pixfirewall(config)# configure factory-default 192.168.1.1 255.255.255.255

Specified IP address (192.168.1.1) is not allowed; it's a broadcast address.

3 REPLIES

Re: PIX 501 setting factory default

if you are using /24 network command syntax should be:

configure factory-default 192.168.1.1 255.255.255.0

or you can do configure factory-default command alone and it will use 192.168.1.1 255.255.255.0 for your inside interface and automatically create DHCPD pool for you on inside interface.

http://www.cisco.com/en/US/docs/security/pix/pix62/command/reference/c.html#wp1055799

Regards

New Member

Re: PIX 501 setting factory default

Jorge,

Neither command seem to work.

pixfirewall(config)# configure factory-default

.

Cannot select private keyWarning: Start and End addresses overlap with broadcast

address.

outside interface address added to PAT pool

pixfirewall(config)# configure factory-default 192.168.1.1 255.255.255.0

Warning: Start and End addresses overlap with broadcast address.

outside interface address added to PAT pool

Re: PIX 501 setting factory default

never seen that before, use a different network address for sake of erasing the config, try 172.16.1.1 255.255.255.0 if success then do it for 192.168.1.1 /24 if not joy you may need to do write erase .

I assume you are doing it from local console

let me know if it worked out

559
Views
0
Helpful
3
Replies
CreatePlease to create content