Our PIX 501 has not been used in about a year. I want to configure it. I can get a login box when I go to https://192.168.1.1/startup.html. I leave the user name and password blank and then I get the "Wait while startup Wizard loads" But nothing happens. That is as far as I can get. I've tried using a Vista machine with IE 7, and an XP machine with IE 6. Both give the same result. Any suggestions?? Thanks
Do you have the light blue Cisco console cable and a laptop with a serial port? Connect it to the console port on the PIX, launch Hyperterminal (9600-8-N-1) and you're good to go. Default login should be pix/, then enable and for the password.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...