Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX 501 w/ ppoe using 1 IP

With a PIX 501 running 6.3(4) connecting to the ISP via PPOE with a static IP, What command syntax can I use to create a static NAT translation from that out side IP to a internal IP For the use of incoming Web traffic, email and things like that.

I have done it with a multiple IP but never done it with just the 1 ip on the outside interface.

thanks!

Brandon

3 REPLIES
Silver

Re: PIX 501 w/ ppoe using 1 IP

Configure static port redirection using the interface statement

static [(internal_if_name, external_if_name)] {tcp|udp} {global_ip|interface} global_port

local_ip local_port [netmask mask]

ex:

static (inside, outside) tcp interface 80 192.168.1.10 255.255.255.255 80

Thanks,

Chad

Please rate if helpful.

Green

Re: PIX 501 w/ ppoe using 1 IP

Chad, just a little typo :)

static (inside, outside) tcp interface 80 192.168.1.10 80 netmask 255.255.255.255

New Member

Re: PIX 501 w/ ppoe using 1 IP

ok thanks guys will try this over the weekend

99
Views
0
Helpful
3
Replies