I am in the process of swapping out a PIX 505 running 5.0(2) to a 515E running 7.2(2). After attempting to convert the older configuration I have not been able to get the new model to work correctly. Even without any ACL applied I cannot get traffic to pass through the PIX. The interface configuration and routing is the same as that on the older model. Any suggestions are greatly appreciated!
ESCPIX# show config
: Written by enable_15 at 06:37:41.748 UTC Thu Jun 21 2007
When I make the swap the interfaces show as up, but show traffic has zeroes across the board. Also, the ping I am running to the internal interface ip address fails after I make the swap. However I have confirmed the physical interface is okay by changing the ip address and connecting to our network. I have the PIX disconnected now and when I try to ping either interface from within the PIX via console I get a "No route to host" message. Not sure if that is normal or not.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...