Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX 506 ppoe

Hello everybody

I have a PIX 506 version 6.3(5), the pix is connect with a modem 2wire, but my problem is that the modem doesn't give ip to PIX (Eth0), I configured pppoe:

vpdn group pppoe_group request dialout pppoe

vpdn group pppoe_group localname xxx

vpdn group pppoe_group ppp authentication pap

vpdn username xxx password xxxx

I ran the debug pppoe command and the pix show me the next:

padi timer expired

Regards,

3 REPLIES

Re: PIX 506 ppoe

The padi timeout means your ISP's PPTP server is not responding at all.

http://www.velocityreviews.com/forums/t33473-pix-501-pppoe-problem.html

Are you sure your ISP uses PAP?

Regards

Farrukh

New Member

Re: PIX 506 ppoe

Hi

Well, I did the next test in the pix and modem:

When the comunication between the pix and the modem is ok, but for any reason the modem or the pix turn off and turn on, the comunication can't be stablished, then I set up the modem in mode router and I back the modem to mode bridge and the pix can stablised the comunication, is this normal??

What can i do for solved this problem??

Regards,

Re: PIX 506 ppoe

Perhaps its time for a firmware upgrade on the modem. This is definitely not normal.

Regards

Farrukh

163
Views
0
Helpful
3
Replies