Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

Pix 506e - Upgrading PDM - syntax?

I'm trying to upgrade my PDM from V3.0(2) to V3.0(3), this is supposed to resolve some issues of connecting to the PDM with newer versions of Java.

Below is the syntax I'm typing in during a hyperterminal session. Obviously it isn't working. Can someone give me the correct syntax?

Copy tftp //tftp-root/pdm-304.bin flash pdm

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: Pix 506e - Upgrading PDM - syntax?

Try using following command syntax-

PIX# copy tftp flash:pdm

Address or name of remote host []? x.x.x.x

Source file name [mybackup]? pdm-303.bin

copying tftp://x.x.x.x/pdm-303.bin to flash:pdm

[yes|no|again]? yes

Assuming that x.x.x.x is the IP address of your TFTP server and pdm-303.bin is the image name.

Hope this helps.

Regards,

Vibhor.

1 REPLY
Silver

Re: Pix 506e - Upgrading PDM - syntax?

Try using following command syntax-

PIX# copy tftp flash:pdm

Address or name of remote host []? x.x.x.x

Source file name [mybackup]? pdm-303.bin

copying tftp://x.x.x.x/pdm-303.bin to flash:pdm

[yes|no|again]? yes

Assuming that x.x.x.x is the IP address of your TFTP server and pdm-303.bin is the image name.

Hope this helps.

Regards,

Vibhor.

167
Views
5
Helpful
1
Replies
CreatePlease to create content