Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX 515 E Opening a port

I need to open port 3306 for inbound traffic on pix 515 E so i added the follwing line in after my other ports:

access-list InboundFilter permit tcp any any eq 3306

I also have the line:

static (inside,outside) (my public removed for security) 192.168.100.3 netmask 255.255.255.255 0 0

Is there any other line i need to add to allow TCP traffic on port 3306?

3 REPLIES
Silver

Re: PIX 515 E Opening a port

You need to make sure that-

- access-group InboundFilter is applied on outside interface of PIX.

- there is no "deny" access-list denying the traffic you just permitted above.

If this is right, then you dont need to put anything else.

Regards,

Vibhor.

New Member

Re: PIX 515 E Opening a port

I belive we have that with this line:

access-group InboundFilter in interface outside

Silver

Re: PIX 515 E Opening a port

You are all set .. :-)

Regards,

Vibhor

115
Views
0
Helpful
3
Replies