Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

PIX 515 failover

Hi there,

Cisco states that a failover config need the same hardware for both nodes. I have two 515's. RAM, SW version, interfaces and licences are no problem, but processor types are different. Does anyone have experience with such a config when set for failover? I do not need the stateful failover option.

Thanks in advance, Meindert.

1 REPLY
Community Member

Re: PIX 515 failover

I have the same and the processors are different.

They work just fine I think you should not worry about this!

Vlad

104
Views
0
Helpful
1
Replies
CreatePlease to create content