Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

PIX 515 issue after trying to upgrade from 601 to 622

Hello,

I am having the following problem on my Cisco PIX 515:

I had been running:

  • Cisco Secure PIX Firewall Version 6.0(1)
  • PIX Device Manager Version 1.0(1)
  • Hardware:   PIX-515, 32 MB RAM, CPU Pentium 200 MHz
  • Flash i28F640J5 @ 0x300, 16MB
  • BIOS Flash AT29C257 @ 0xfffd8000, 32KB

I upgraded the PIX to pix622.bin.  That seemed to work, but the PIX did not boot after reload.

So I reverted it to pix601.bin.

That seemed to work, and my configuration file was still in place and all my services worked as before.

However, upon reload I get the following error:

Reading 2445824 bytes of image from flash.

32MB RAM

imgsum_config: sumval(0x1f8e) md5(0x95937073 0x75b817db 0x54d7811a 0xba7d0214)

imgsum_verify: chksum(0x   0) md5(0xf9d77cec 0xfca32e88 0xb13f21e9 0xfa81733b)

Panic: kernel - The checksum verification for this image failed.

Thoughts?  Help?

2 REPLIES
Cisco Employee

PIX 515 issue after trying to upgrade from 601 to 622

You get this error using the console right?

Mike

Mike
New Member

PIX 515 issue after trying to upgrade from 601 to 622

Correct.

383
Views
0
Helpful
2
Replies
CreatePlease to create content