Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

PIX 515 to ASA 5540

Hi all,

i want anything help me to get the configuration file from pix515 to put it on cisco asa5540

pix version is 3.1 , ASA version 8.0

when i copied it manually it didn't work , i don't know why??

Best Regards,

Ayman

2 ACCEPTED SOLUTIONS

Accepted Solutions
Cisco Employee

Re: PIX 515 to ASA 5540

PIX version 3.1 is an extremely old version of code (back in 1997), therefore it will no longer work for ASA. It will not even work for PIX version 6.x, 7.x and 8.x anymore.

I would recommend that you build the ASA from scratch. I wouldn't think there will be too many features on PIX version 3.1 so configuring the ASA from scratch should not be too complicated.

Cisco Employee

Re: PIX 515 to ASA 5540

Good questions

Not sure if copying exist in that version.

Here is the command reference for version 3.x, it might help you:

http://www.cisco.com/en/US/docs/security/pix/pix30/user/guide/pixugcmd.html

Looks like the only command to obtain the configuration is "show config" or "write terminal".

Hope that helps.

4 REPLIES
Cisco Employee

Re: PIX 515 to ASA 5540

PIX version 3.1 is an extremely old version of code (back in 1997), therefore it will no longer work for ASA. It will not even work for PIX version 6.x, 7.x and 8.x anymore.

I would recommend that you build the ASA from scratch. I wouldn't think there will be too many features on PIX version 3.1 so configuring the ASA from scratch should not be too complicated.

New Member

Re: PIX 515 to ASA 5540

Hi jennifer,

thanks for your reply.

could you provide me the way to get the configuration file from that pix via tftp as there is no show flash or no disk0:and i don't know where the config file is stored?

and i want to get the config file from it to make sure that their is nothing missing.

Thanks,

Ayman

Cisco Employee

Re: PIX 515 to ASA 5540

Good questions

Not sure if copying exist in that version.

Here is the command reference for version 3.x, it might help you:

http://www.cisco.com/en/US/docs/security/pix/pix30/user/guide/pixugcmd.html

Looks like the only command to obtain the configuration is "show config" or "write terminal".

Hope that helps.

New Member

Re: PIX 515 to ASA 5540

Dear Jennifer,

Thanks so much for help

Thanks ayman

215
Views
0
Helpful
4
Replies
CreatePlease to create content