Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

PIX 515 ver 6.3 (5)

I need to make sure that the firewall is listening to accept traffic destined to this address, 10.10.10.4 on port 80, or if it is for  68.179.71.3.  The traffic should be going in and out the same path to avoid asiymetric routing  This not happening because I cannot get traffic through to and from my webserver.  what is the best solution for this isuue? 

The ip address outside 10.10.10.1 255.255.255.0

The ip address inside 192.168.1.1 255.255.225.0

The ip range 10.0.10.0 255.255.255.0 cannot get traffice to and from my webserver.

What is the solution to my problem?  Thank you

Everyone's tags (1)
1 REPLY
New Member

PIX 515 ver 6.3 (5)

kindly provide your running config... you can remove the passwords and change the actual ip address with dummy ones.    

468
Views
0
Helpful
1
Replies
CreatePlease to create content