Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PIX 515 Will Not Read Flash Image

Use BREAK or ESC to interrupt flash boot.

Use SPACE to begin flash boot immediately.

Flash boot in 8 seconds.

Can not use esc or break, it just keeps looping back to:

Use BREAK or ESC to interrupt flash boot.

Use SPACE to begin flash boot immediately.

Flash boot in 8 seconds.

6 REPLIES

Re: PIX 515 Will Not Read Flash Image

when using brake to interupt boot can you get to rommon> prompt? sounds you may need to upload new image.

New Member

Re: PIX 515 Will Not Read Flash Image

it does nothing when I use brake, it just tries to load the falsh and then loops back

New Member

Re: PIX 515 Will Not Read Flash Image

try to use ESC key and then see what happend

New Member

Re: PIX 515 Will Not Read Flash Image

I have tried the esc key also

New Member

Re: PIX 515 Will Not Read Flash Image

I think the problem is at confreg file.

Try to use BREK+SHIFT ore BREAK+CTRL

Re: PIX 515 Will Not Read Flash Image

Have you tried changing the DRAM out? I've seen DRAM go bad in a 515 and it would cause something like this. The only other time I have seen this is with a dead 515.

-brad

www.ccbootcamp.com

(please rate the post!)

145
Views
0
Helpful
6
Replies