01-12-2007 06:35 AM - edited 03-11-2019 02:18 AM
Hello,
I have a test pix that has developed a boot problem. When booting it displays the PCI Device Table and then hangs.
Has anyone come across anything like this before and have any ideas what is causing this?
Thanks,
Andy.
Solved! Go to Solution.
01-12-2007 08:57 AM
Hello,
The solutiojn to this is to open the PIX and there you will find a battery. Remove the battery for some couple of minutes and then install the battery again. The PIX should boot normally.
Hope this solves your issue and Appreciate your Rating,
Regards,
01-12-2007 08:57 AM
Hello,
The solutiojn to this is to open the PIX and there you will find a battery. Remove the battery for some couple of minutes and then install the battery again. The PIX should boot normally.
Hope this solves your issue and Appreciate your Rating,
Regards,
01-12-2007 09:09 AM
Working again.
Cheers.
01-14-2007 11:37 PM
Hello,
I have this problem two year ago, and the solution is change the PIX. A temporal solution is open the PIX box and change the position of the internal jumper, with this solution the PIX startup well, but it fails again after a few time. For this reason you need you need replace the PIX.
Good luck
Agsuti
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: