Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

pix 515E can't use the Fe0 and Fe1

Dear sirs,

i have cisco pix 515E with three interfaces Fastethernet0, Fastethernet1 and built-in in the pix and Fastethernet2 which is module.

i upgrade it to ver. 7.0

when i connect the firewall the fe0 and Fe1 is bring up and the light is ok but i can ping them or use them , but the interface Fe2 which module is ok i can ping it or use it.

Is it hardware failure or what.

1 REPLY
New Member

Re: pix 515E can't use the Fe0 and Fe1

sorry,

i mean i can not ping or use the Fe0 or Fe1, but i can use and ping the Fe2.

i use simple configuration on the pix ( inside , outside and Dmz).

97
Views
0
Helpful
1
Replies
CreatePlease login to create content