Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

PIX 515e DHCP options

In the Cisco PIX (version 7.2) CLI, I’ve been trying to set the dhcp options so that the PIX can run as a DHCP server on the inside interface.  I can set all the options correctly except for option 130.  Below are my failed attempts to set option 130 to the value 'MITEL IP PHONE'.  The problem is that the CLI does not accept spaces.  Attached is the PIX running config file.

pixfirewall(config)# dhcpd option 130 ascii MITEL IP PHONE

                                                   ^

ERROR: % Invalid input detected at '^' marker.

pixfirewall(config)# dhcpd option 130 ascii "MITEL IP PHONE"

Too many ASCII strings

Usage: dhcpd address <ip1>[-<ip2>] <srv_ifc_name>

        dhcpd dns <dnsip1> [<dnsip2>] [interface <srv_ifc_name>]

        dhcpd wins <winsip1> [<winsip2>] [interface <srv_ifc_name>]

        dhcpd lease <lease_length> [interface <srv_ifc_name>]

        dhcpd ping_timeout <timeout> [interface <srv_ifc_name>]

        dhcpd domain <domain_name> [interface <srv_ifc_name>]

        dhcpd option <code> {ascii <string> | hex <hex_string> |

                ip <address_1> [<address_2>]} [interface <srv_ifc_name>]

        dhcpd enable <srv_ifc_name>

        dhcpd auto_config <clnt_if_name> [interface <srv_ifc_name>

        dhcpd update dns [both] [override] [interface <srv_ifc_name>]

        show dhcpd [binding|statistics]

        clear dhcpd

        clear dhcpd [binding|statistics]

pixfirewall(config)# dhcpd option 130 ascii 'MITEL IP PHONE'

                                                    ^

ERROR: % Invalid input detected at '^' marker.

pixfirewall(config)#

The option must be "MITEL IP PHONE" (minus quotes) in order for the Mitel phone to accept the value and the DHCP offer.

Any ideas?

Thanks

Everyone's tags (2)
1 REPLY
Cisco Employee

Re: PIX 515e DHCP options

Hello,

The variable cannot contain whitespace. The output of 'help dhcpd' shows:

        ASCII string without whitespace

Unfortunately there is no way to specify a string that contains whitespace, so if your phone requires a certain string it would seem that this won't be supported.

Hope that helps.

-Mike

2424
Views
0
Helpful
1
Replies
CreatePlease to create content