I have a PIX 515E - the DMZ port is not used presently. I am changing ISPs. I already have the new ISP components connected and running as advertised. I want to verify all is going to work correctly with my static routes and the new ISP before cancelling the old ISP. I am wanting to connect the new ISP to the DMZ port to test the static routes. Is this possible and if so, what type of additional statements should to be added to give the DMZ FULL access to the network?
you solved my issue in trying to use the DMZ port - in that I cannot do it without shutting down the network since I use ver 6.3 (5). We work 24/7/365. The network cannot be down for more than a few minutes and then it shouldnt be our (the IT dept) fault.
I'll look at getting another firewall and trying it that way.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...