Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

pix 515e failover not happening

i recently upgraded my pix 515e from 6.35 to 7.22 but from then i am not able to configure failover . an error message comes on the secondary pix as VPN-3DES-AES : Disabled

I believe that this feature in the pix is disabled so the failover is not working

Pl suggest how to enable this

2 REPLIES
New Member

Re: pix 515e failover not happening

Do a show version on both pix's to confirm whether you have VPN-3DES-AES enabled.

Read through these about how to enable it (you will need a valid PAK key to do so) - and the other is a guide for upgrading from 6.x to 7.x

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a00806b1c0f.shtml

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note09186a00804708d8.shtml#t7

Cheers,

Peter

New Member

Re: pix 515e failover not happening

If you are using the graphical web interface make sure you have the latest version of ASDM on both devices. I had a similar issue a while ago where ASDM reported a compatability issue, and I had to use an interim release to get things going.

121
Views
0
Helpful
2
Replies
CreatePlease login to create content