ISP--PIXTransparentMode--Switch 2950--Servers, my ISP gives me the Ip network, all servers use the same gateway (ISP) same mask,right now switch is plane no vlans and evertyhing working fine and i need to create 2 vlans in my switch, i create it , i assigned the ports for vlans, in the port in switch where the firewall is connected is in switchport mode trunk, but after this change, my servers dont reach gateway neither vlan A and vlan B, did i miss something, they are using the same IP's, gateway,etc, do i need to do something in the PIX 515E in transparent mode?, i just need to create vlans in switch but i cannot reach the gateway, i just have on ISP.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...