Cisco Support Community
Showing results for 
Search instead for 
Did you mean: 

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Pix 515E unable to ping directly connected interface

Hi how are you all doing? I have a quick question here. I've added another inside interface to my Pix eth2 with an ip address of and the distant end is a 2821 g0/0 with ip now from the pix I can ping eth2 but when I try to ping the .50 I cannot ping it. I ran a debug but all that did was confirm that I cannot ping .50. I can ping the .49 address and I can see that the route is in the routing table when I do a show route I see "intf2 1 CONNECT static" I also swapped out the cables 3 times already using cross cables. Am I missing something?

New Member

Re: Pix 515E unable to ping directly connected interface

you have to allow pings to the pix.


no deny icmp any inside


CreatePlease login to create content