Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

PIX 515E

hi,

I just want to check if this is possible.

PIX 515E running 6.3

I want certain internal networks to

use a different PAT global address.

192.168.1.0 ---- > PAT to 203.115.155.1

192.168.2.0 -----> PAT to 203.115.155.2

so in this case anything coming from 192.168.1.0 will be translated to 203.115.155.1 on the outside interface

anything coming 192.168.2.0 will be translated to 203.115.155.2 on the

outside interface.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: PIX 515E

Sure, use a different NAT ID to group them to the corresponding global (PAT) address.

nat (inside) 1 192.168.1.0 255.255.255.0

nat (inside) 2 192.168.2.0 255.255.255.0

global (outside) 1 203.115.155.1

global (outside) 2 203.115.155.2

HTH

Sundar

1 REPLY

Re: PIX 515E

Sure, use a different NAT ID to group them to the corresponding global (PAT) address.

nat (inside) 1 192.168.1.0 255.255.255.0

nat (inside) 2 192.168.2.0 255.255.255.0

global (outside) 1 203.115.155.1

global (outside) 2 203.115.155.2

HTH

Sundar

132
Views
0
Helpful
1
Replies
CreatePlease to create content