Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

pix 525 6.3(3) logging queue full

I have a pix 525 that has stopped logging. for some reason the logging queue gets full and then nothing else happens. I have tried removing all Logging statements from the config and putting them back and have even reloaded it. After a reload I get about 10 lines in the log and then it stops logging again. Below is a snapshot of the sh logg queue command. The max messages show 512 but the log queue is showing 8192. This is because I tryied changing the max queue size and when that did not work I set it back to default. Does anyone know how to clear the queue and get it logging again.

Logging Queue length limit : 512 msg(s), 1576702 msg(s) discarded.

Current 8192 msg on queue, 8192 msgs most on queue

132
Views
0
Helpful
0
Replies