I've configured 2 pixes, (active / standby) and worked fine for one day then lost one of them,
I spent about 8 hours to fix the issue without luck, can I run only one of them? as I have to get the network running within 24 hours (we have a conference on Friday), if yes, how should I do it? do I need to disconnect the failover link and disable the failover? could anyone help please and let me know how to do it?
I believe, I have to run only one of them (at the moment) because the network works ok for 20-30 mins and the stops and works again after 2-3 mins.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...