I have a 525 bundle but one of the firewalls will not boot up anymore. It gets to a certain point and then just hangs. These two firewalls were just recovered from a client site so I'm guessing at this point what may have happened. Is there a typical cause for this type of issue when the boot up just hangs? Below is all I see when consoled into the pix during boot up.
CISCO SYSTEMS PIX FIREWALL
Embedded BIOS Version 4.3.207 01/02/02 16:12:22.73
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...