Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

PIX 525 in failover

HI,

Please guide me for the following

I have 2 PIX525 in failover mode.

In the primary I have configured the following

failover

failover timeout ----sec

failover poll --sec

failover IP address inetrface 1 (Secondary PIX Interface IP address)

failover IP address interface 2 (secondary PIX interface IP address)

In the secondary PIX525

failover

failover timeout ----sec

failover poll --sec

failover IP address inetrface 1(Primary PIX interface IP address)

failover IP address interface 2 (Primary interface IP address)

Is there any other configuration required.or stateful inspection what is the command?

Please help me.

Thanks and Regards,

S.Venkataraman.

1 REPLY
Silver

Re: PIX 525 in failover

Hi,

What kind of failover are you trying to, it looks like you want Active/Standby. Cable based or Lan based?

I suggest you have a look at this webpage, it gives you complete Failover configuration in Active/Standby state.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00807dac5f.shtml

For Active/Active have a look here

http://www.cisco.com/en/US/products/ps6120/products_configuration_example09186a0080834058.shtml

For 6.3 use this page

http://www.cisco.com/en/US/docs/security/pix/pix63/configuration/guide/failover.html

-Hoogen

Do rate helpful posts :)

144
Views
0
Helpful
1
Replies
CreatePlease to create content