I am tasked with upgrading the Pix firewall license to primary as well as upgrading the OS. However, when I connect, it appears to be continuously reloading and cannot be interrupted. Only when I do esc while it's rebooting can I get the monitor> prompt. From there I can't do "enable" or much else. Just a few commands are allowable which don't appear to be helpful. Any ideas?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...