Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

pix 525 regular interface or redundant interface

i am configuring a pix 525

i just found out how to activate the subinterface on it so that's good

the box has a primary unit and secondary unit, both are connected from G0 to redundant switches

if i do a show failover, it says it's using the serial based lan failover, which is fine by me

however, do i need to create a single, regular interface.. or a redundant interface?

i.e. if i create a regular subinterface, will failover still apply to this interface?

or for failover to work, do i need to create a redundant interface (with a redundant id)? i do not seem to have the option to create a subinterface when adding a redundant interface

i am trying to initiate failover for this subinterface

Everyone's tags (6)
1 REPLY
Cisco Employee

pix 525 regular interface or redundant interface

Hello Axel,

Not by default. You will need to use the monitor-interface command. Redundant interfaces are not necessary, they are just another layer of redundancy.

Mike

Mike
310
Views
0
Helpful
1
Replies
CreatePlease to create content