Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

Pix 525 through put question

  Hi

We're having an issue with out Pix 525 cluster, what we're seeing is the following:

* using iternet speed tests while going through the Pix we have trouble getting past 40Mbps of our 100Mbps pipe.

* When I place the laptop outside the Pix we get 90+ Mbps. This is still going through the same internet switch and router.

* Pix CPU, Memory etc in the ADSM dashboard don't show anything that would explain this.

* switch ports that the Pix connects into seem fine, no errors.

I will be going through them again, but if they are fine I'm wondering what I can look at next. Is there a command that might show if the Pix is being taxed?

thanks

John                

1 REPLY
New Member

Pix 525 through put question

Hi John,

Try to connect laptop directly to Pix interface and then check what exactly the speed you are getting, by that I mean just bypass the switch.

- Prateek Verma

90
Views
0
Helpful
1
Replies
CreatePlease to create content