The pix 535 comes with two built in 10/100 ports. I plan to purchase and install gigabit modules. I wish not to use the inside and outside built in 10/100 ports and wish to configure the gigabit modules 10/1000 and the inside and outside. Is this possible
If you decide to upgrade from 6.3(x) to 6.3(5) or to 7.x, in monitor mode, you will NOT see the Gig, interfaces, only the Fast Ethernet, assuming that you have the Fast Ethernet in the 33Mhz slot. If you have the Fast Ethernet in the 66Mhz bus as well, you are F!.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...