Re: PIX 6.3.3 Failover problem - been working for months
If the configuration hasn't changed at all, it might be a hardware issue with one of the interfaces on the secondary unit. If you do a 'sh int' on the secondary unit, do you see a large number of errors on any of the interfaces?
Is the state interface (intf5) directly connected on both units or is it going through a switch?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...