Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Pix(6.3(3)) to PIX (7.0 or 7.2(2) conversion

Dear all,

I have Pix 520(6.3(3)) and i'd like to replace it with another one PIX525 (7.0 or 7.2(2)) But the problem is in the old config ( Conduit ,Fixup,interfaces , VPN and...)

how can i convert (move) the old config (6.3(3)) to the new one (7.2(2) or 7.0) and what about the activation key or the licence?

1 REPLY
New Member

Re: Pix(6.3(3)) to PIX (7.0 or 7.2(2) conversion

I have done a few of these upgrades, with little to no problem. Any particular reason you ruled out 8.0(2) code? Anyway, I recently upgraded a 6.3(4) straight to 8.0(2) and had one problem, the remote user VPNs did not make it over cleanly. The Site to site VPNs did (and all other configuration). The only specific information in your list was I did not have conduits (nor any of my other upgrades). Fixup pretty much gets replaced with inspect maps.

Hope this helps,

Mike

88
Views
0
Helpful
1
Replies