Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Pix(6.3(3)) to PIX (7.0 or 7.2(2) conversion

Dear all,

I have Pix 520(6.3(3)) and i'd like to replace it with another one PIX525 (7.0 or 7.2(2)) But the problem is in the old config ( Conduit ,Fixup,interfaces , VPN and...)

how can i convert (move) the old config (6.3(3)) to the new one (7.2(2) or 7.0) and what about the activation key or the licence?

2 REPLIES
New Member

Re: Pix(6.3(3)) to PIX (7.0 or 7.2(2) conversion

conduits are the big thing.

You will need to make an access-list containing all of your conduit statements. This access-list will need to be applied inbound on the outside interface using:

access-group in interface outside

Thats the biggest difference, alot of it will be similar. VPN would be another big difference. Check out the "group-policy" command and the "tunnel-group" commands and examples of each if you have VPN's terminating on the device.

New Member

Re: Pix(6.3(3)) to PIX (7.0 or 7.2(2) conversion

yes there are many conduit commands and vpn too .

I have heard aout the tool conversion did u use it?

94
Views
0
Helpful
2
Replies