Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

PIX 6.3 NAT for snmp traps

Hi Everyone,

wonder if any one can advise me on this.

Have an outside snmp monitoirng server polling clients on the inside. All the outside managment service networks (that is 2) are PAT'd to the inside ip of 192.168.1.10

I use this to that

global (inside) 1 192.168.1.10

nat (outside) 1 access-list NAT_OUTSIDE_MGR outside 0 0

access-list NAT_OUTSIDE_MGR permit 10.1.1.0 255.255.255.0 192.168.10.0 255.255.255.0

access-list NAT_OUTSIDE_MGR permit 10.1.2.0 255.255.255.0 192.168.10.0 255.255.255.0

static (inside, outside) 10.1.1.0 10.1.1.0 255.255.255.0

static (inside, outside) 10.1.2.0 10.1.1.0 255.255.255.0

All good there I think.

Now when the clients are configured for the snmp trap address of the PAT IP of 192.168.1.10 how do I configure the PIX to send all the trap messages to those networks 10.1.1.0 & 10.1.2.0

Cheers

Tony

Everyone's tags (1)
375
Views
0
Helpful
0
Replies
CreatePlease to create content