Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)

PIX/ASA Failover Design

Hi!

Are there anybody here tried to setup A/A failover or A/S Failover with DMZ support?

I read the docu found here

http://cco.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_62/config/failover.htm#40447

and it seems DMZ support is not supported. correct me if im wrong. I attached the network topology.

Need your comments. Thank you!

Please rate replies and mark question as "answered" if applicable.
2 REPLIES
Community Member

Re: PIX/ASA Failover Design

I can't figure out if I have to dedicate an interface on the ASA JUST for failover/stateful traffic.

Re: PIX/ASA Failover Design

In order to implement failover either A/A or A/S you must dedicate 1 port for failover.

Please rate replies and mark question as "answered" if applicable.
242
Views
0
Helpful
2
Replies
CreatePlease to create content