Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Cisco Support Community site will be in read only mode on Dec14, 2017 from 12:01am PST to 11:30am for standard maintenance. Sorry for the inconvenience.

New Member

PIX Boot Problem

I have PIX 515E Firewall when I statrt it the following message appear in Hyper Terminal.

CISCO SYSTEMS PIX FIREWALL

Embedded BIOS Version 4.3.207 01/02/02 16:12:22.73

Compiled by morlee

64 MB RAM

PCI Device Table.

Bus Dev Func VendID DevID Class Irq

00 00 00 8086 7192 Host Bridge

00 07 00 8086 7110 ISA Bridge

00 07 01 8086 7111 IDE Controller

00 07 02 8086 7112 Serial Bus 9

00 07 03 8086 7113 PCI Bridge

00 0D 00 8086 1209 Ethernet 11

00 0E 00 8086 1209 Ethernet 10

00 11 00 14E4 5823 Co-Processor 11

If anyone can guide me because my network is down for a few days

5 REPLIES
Gold

Re: PIX Boot Problem

Is that were it stops? does it keep rebooting continuously? Or does it go into rommon mode?

New Member

Re: PIX Boot Problem

Yest it stop even i can not go rommon mode by disturbing it by ESC or Break

New Member

Re: PIX Boot Problem

Is there anyone to help me. The message which I posted the firewall stack after that. I cannot go to any mode. Please if anyone can help me.

Thank you in advance

Re: PIX Boot Problem

as indicated by zubairjalal, you will have to rma it hoping you have a backup of the config , also it would be recomended to deploy a ASA failover solution, with this solution your network will not be down.

Bronze

Re: PIX Boot Problem

I think you should proceed with a RMA.

regards

Zubair

156
Views
0
Helpful
5
Replies
CreatePlease to create content