can any one help with the diff. between these two pix commands
pix(config)# clear access-list
pix(config)# clear configure access-list
all cisco documentations says that the second command clear the acl from the running config, so if i do copy run start it will not come back next boot and if reload without saving it will come back, same thing to clear access-list commmad???
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...