Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

PIX code upgrades from ver 6.2.1 to 6.3.5 - recomendations

Could someone advice me on upgrade process for a set of 515E PIXes firwall code and pdm version upgrades.

I will be upgrading a set of pixes in a failover configuration, I have read the upgrade process for failover firewalls and seems fearly straight forward but my question is, would it be feasable when tftping the new version to also tftp the pdm image file upgrade as well, is this something that can be done all together in one process or would it be best to upgrade the code one at a time, that is firewall code first and got through the boot/failover process and tftp the PDM image on another install process.

Current:

PIX Models PIX515E

Unrestricted

64 RAM, FLASH 16MB

Version 6.2.1 ( Upgrating to 6.3.5)

pdm ver 2.0.2 ( upgrading to 3.0.4)

Thanks much

Jorge

2 REPLIES
New Member

Re: PIX code upgrades from ver 6.2.1 to 6.3.5 - recomendations

Hi,

If i were to upgrade a pix firewall running in failover i would have First upgraded the firewalls in failover & would have ensured smooth functioning of the device after upgrade and then would have upgraded the PDM version.

Thanks

gagan

Re: PIX code upgrades from ver 6.2.1 to 6.3.5 - recomendations

Gagan thanks for your input, fair enough.. good point on failover verification/functionality before moving to pdm upgrades.

Thanks

Jorge

199
Views
5
Helpful
2
Replies