Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX Configuration

Could someone review my config? I need all traffic to flow accross the tunnel from one network to the next. I believe my access list and crypto map is right.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: PIX Configuration

Crypto access list is fine but the access-list configured on the interface is also referencing the same access-list which is wrong.

Since you do not have the sysopt connection permit-IPSec command configured, you would be required to allow the IPsec traffic in your access-lists applied on the interface

Have a look at this link for a PIX-to-PIX IPSEC config example

http://www.cisco.com/warp/public/110/38.html

HTH

Narayan

1 REPLY

Re: PIX Configuration

Crypto access list is fine but the access-list configured on the interface is also referencing the same access-list which is wrong.

Since you do not have the sysopt connection permit-IPSec command configured, you would be required to allow the IPsec traffic in your access-lists applied on the interface

Have a look at this link for a PIX-to-PIX IPSEC config example

http://www.cisco.com/warp/public/110/38.html

HTH

Narayan

114
Views
0
Helpful
1
Replies