Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PIX Failover issues after upgrade from 7.04 to 7.21

I have a pair of 525's which failover anyware from 5 to 10 times a day since my upgrade to 7.21.

I started with my standard Failover config using the serial cable and a dedicated interface for statefull failover. In the process of troubleshooting I have tried network based failover with statefull and serial failover without statefull, but to no avail. Anyone have any insite to this madness?

Log: 2006-11-30 14:43:04 Local4.Alert 10.x.x.x Nov 30 2006 13:44:21: %PIX-1-104001: (Secondary) Switching to ACTIVE - HELLO not heard from mate.Nov 30 2006 13:44:21: %PIX-1-104001: (Secondary) Switching to ACTIVE - HELLO not heard from mate.

4 REPLIES
Cisco Employee

Re: PIX Failover issues after upgrade from 7.04 to 7.21

Ken,

Is this the only log that you are seeing on the pix. Do you see any crash file on both the pixes.

- Arul

New Member

Re: PIX Failover issues after upgrade from 7.04 to 7.21

Arul,

Where would the Crash file be Located?

Ken...

New Member

Re: PIX Failover issues after upgrade from 7.04 to 7.21

I had exactly the same problem with a pair of PIX515e, after upgrading to 7.2.1. My only solution was to move them closer together and to use the serial cable. After that all was fine.

Hope this helps

Dave Beattie

New Member

Re: PIX Failover issues after upgrade from 7.04 to 7.21

Dave,

Funny as these units are racked one on top of the other. I also have a redundant pair of 525 which we use for our lab envionment which are configured with the same hardware and IOS. The config differes only with number of interfaces in use and ACL's. This pair has no issues and is also racked together. I am thinking about switching the serial failover cables to see if that makes a difference.

Thanks for post though.

Ken...

149
Views
0
Helpful
4
Replies