05-21-2007 11:08 AM - edited 03-11-2019 03:17 AM
Hi.As I don't have much experience with PIXes I'm seeking some advice concerning following failover configuration.I have 2 PIXes connected through a failover cable and after entering show failover command I get the result that my secondary PIX is in active status and my primary PIX is in standby status.
All interfaces on both primary and secondary PIX are showing as normal along with cable status.What I was wondering is if my secondary PIX that is now active goes offline will the primary PIX currently in standby take over?If not how can I make sure it does?
Solved! Go to Solution.
05-21-2007 11:33 AM
Hi
This is fine. if the standby firewall fails then yes your primary firewall will become active again.
HTH
Jon
05-21-2007 11:33 AM
Hi
This is fine. if the standby firewall fails then yes your primary firewall will become active again.
HTH
Jon
05-21-2007 11:44 AM
Thanks for the fast reply Jon.I wasn't sure it would work like that considering my secondary PIX is active and I don't have much experience in that area but your answer eased my mind quite a bit.Thanks.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide