Its says link unconfigured on the secondary unit. Primay Pix crashed so we have to get it back online. why the link is shown unconfigured?
Also when primary is bought up again, if i dont copy the entier config from TFTP and just configure interfaces with failover commands, the secondary should see primary up . then if i do write standy by will it copy the config from secondary to primary unit? once done i want to force primary to be active. but with the stateful link shown unconfigured on secondary, i m not sure how will stateful failover work. can you guys help here
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...