Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
New Member

PIX Failover

Hi,

Should I use the PIX failover IP address of the outside interface as the default gateway for my external switch?

Gavin

2 REPLIES

Re: PIX Failover

For you to access your switch from inside? I don't see a problem with that.

Silver

Re: PIX Failover

Im not sure about the requirements of doing so. Also, if you configure the default-gateway to the failover IP of the Outside interface of PIX, this wont be a good idea because if PIX recieves the traffic on the Failover IP, PIX will not route that traffic. This IP is only used for failover communications between the Outside interfaces of PIX.

Regards,

Vibhor.

147
Views
0
Helpful
2
Replies
CreatePlease to create content