Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

PIX interfaces ????

hi

we are configuring a PIX 525 and facing a prob that after assing the Ip add to an interface we have observed that interfce is administravitivly Down what can i do,,

I have read on cisco site intsert new card in it and than use write mem for it i could nt unserstand it .. can you tell us abuot it..

which new card ????

Thanks and regards

2 REPLIES

Re: PIX interfaces ????

Hi,

By default all the interfaces will be in shut state in the configuration.

Try issuing "no shut" on the interface configuration mode and saving the configuration.

-VJ

New Member

Re: PIX interfaces ????

doind a no shut in the particular interface will not work for a firewall.

Try the following syntax....

interface < hardware_id>

eg:

interface ethernet0 100full

interface ethernet1 100full

124
Views
8
Helpful
2
Replies
CreatePlease to create content