Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX IP local pool for VPN

We have a PIX 506 that we use for remote access VPN. It's setup with a local IP address pool for handing out addresses to remote clients.

We've noticed that the addresses given out seem to increment over time as if they are not recycled back into the pool after the VPN session is finished.

The PIX is running 6.3(5).

Anyone else experienced this and is there a fix?

Cheers,

Kevin

2 REPLIES
Silver

Re: PIX IP local pool for VPN

Shutdown and no shut the firewall outside interface through which IP's are assigned to clients.

Green

Re: PIX IP local pool for VPN

Why is this something that needs fixed? The pool is there to be used, if there are too many addresses, then make the pool smaller. Once it uses all the addresses, it will start over again from the beginning.

119
Views
0
Helpful
2
Replies