Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX NAT rule

I have a PIX 506e with code version 6.3(5) on it and I am trying to put in a PAT rule so that anything that doesn't have a static NAT configured uses the outside interface's ip address. This is what I have:

nat (inside) 10 10.0.120.128 255.255.255.192 0 0

global (outside) 10 interface

Is this correct? I need all the other static nat's to still be in use. Thanks!

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

PIX NAT rule

If 10.0.120.128/26 is your internal network, then this is correct.

-- 
Don't stop after you've improved your network! Improve the world by lending money to the working poor:
http://www.kiva.org/invitedby/karsteni


--
Don't stop after you've improved your network! Improve the world by lending money to the working poor: http://www.kiva.org/invitedby/karsteni
1 REPLY
VIP Purple

PIX NAT rule

If 10.0.120.128/26 is your internal network, then this is correct.

-- 
Don't stop after you've improved your network! Improve the world by lending money to the working poor:
http://www.kiva.org/invitedby/karsteni


--
Don't stop after you've improved your network! Improve the world by lending money to the working poor: http://www.kiva.org/invitedby/karsteni
94
Views
0
Helpful
1
Replies
CreatePlease to create content