Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

PIX OS 8 corrupting connection log

Recently, I updated the OS and ASDM on the PIX 515E. It is now OS 8.0(2) ASDM 6.0(2). When the PIX is rebooted and logged in via terminal session, the "show conn" command gives a clean connection state. If I set terminal pager 0, and then do a "show conn" connection state is corrupted, and will be corrupted every time after this. Clean reboot of the PIX and show conn works fine again until terminal pager 0 is set.

2 REPLIES
Silver

Re: PIX OS 8 corrupting connection log

Hi,

What's memory Do you have?

Memory Requirements

If you are using a PIX 515/515E running PIX Version 6.2/6.3, you must increase your memory before upgrading to PIX Version 8.0(2). This version requires at least 64 MB of RAM for Restricted (R) licenses and 128 MB of RAM for Unrestricted (UR) and Failover (FO) licenses. Table 1 lists the default value for the memory that ships with each security appliance and flash memory requirements for Version 8.0(2).

Table 1 Default Memory Shipped and Flash Memory Requirements

PIX Security Appliance Model Default Memory (MB) Flash Memory Required (MB)

515/515E

64

16

525

128

535

512

SYSTEMS REQUIREMENT:

http://www.cisco.com/en/US/customer/products/sw/secursw/ps2120/prod_release_note09186a0080852c29.html

Regards

Community Member

Re: PIX OS 8 corrupting connection log

The specs on myx PIX515E are:

Total Flash: 16MB, Total Memory: 64MB, Context Mode: Single, Firewall Mode: Routed, Encryption 3DES-AES, GTP/GPRS: Disabled, Failover: Disabled, VPN Peers: Unlimited, Max VLANs: 10, Max Physical Interfaces: 3, and License: Restricted(R).

154
Views
0
Helpful
2
Replies
CreatePlease to create content