PIX- policy for a source

[sundarr]

In PIX FW is it possible to configure a policy to route the traffic from specific source to use a different gateway and rest of the network pointing to default route.

Thanks in advance

regards

R. Sundararajan

[ajagadee]

Sundar,

Policy Based Routing is not supported on the Pix Firewall.

Also, dont get confused when you see the "route-map" command option in Pix 6.3 and higher. This command is applicable only when redistributing routes into OSPF.

Pix 6.3 Command Reference:

http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_sw/v_63/cmdref/mr.htm#wp1017196

Pix 7.2 Command Reference

http://www.cisco.com/univercd/cc/td/doc/product/multisec/asa_sw/v_7_2/cmd_ref/qr_711.htm#wp1648744

Let me know if it helps.

Regards,

Arul

** Please rate all helpful posts **