Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Step-by-Step Configuration and Troubleshooting Best Practices for the NGFW, NGIPS and AMP Technologies A Visual Guide to the Cisco Firepower Threat Defense (FTD)
Community Member

PIX proccesor up to 90%

I have a PIX 515E. Sometimes when users try to connect with VPN Client, the Processor goes up to 90% and the users are not allowed to log in.

Any idea?

4 REPLIES
Cisco Employee

Re: PIX proccesor up to 90%

Klodian,

Below are two good links to begin to monitor the pix.

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note0918

6a008009456c.shtml

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_tech_note0918

6a008009491c.shtml

The issue may or may not be related with VPN but the above two links should point you in the right direction.

I hope it helps.

Regards,

Arul

** Please rate all helpful posts **

Community Member

Re: PIX proccesor up to 90%

Sorry, but the links are broken-links.

Regards

Kledi

Cisco Employee

Re: PIX proccesor up to 90%

Kledi,

I checked the link and its working. Did you copy paste the full link.

- Arul

Community Member

Re: PIX proccesor up to 90%

Yes you're right. I just clicked on it. Anyway i realized shortly after writing the other message that the link continued.

Well Sorry and Thanks.

Regards

Kledi

202
Views
0
Helpful
4
Replies
CreatePlease to create content