Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PIX translation I want to understand

Hello all,

i created a new sub interface on my PIX with the same security level as another one. The option : "enable traffic between two or more interfaces which are configured with the same security levels". on each objects on both interfaces in the NAT on ASDM i see "NO TRANSLATION REQUIRED SAME SECURITY LEVEL COMMUNICATION IS ENABLED" so i don't need to change something but when i create an ACL to allow traffic on one to the other interface ASDM tells me that there is no address tranlastion configured to go to the second interface.

PIX VERSION : 7.0(4) ASDM Version : 5.0(4)

Can you help me ?

Thank you

3 REPLIES
New Member

Re: PIX translation I want to understand

hello,

no one can help me ?

thank you

Gold

Re: PIX translation I want to understand

can you post the relevant portions of your config?

so you have the following command in your config:

same-security-traffic permit inter-interface

if you have that command configured, you don't need acl's to communicate between the two interfaces.

New Member

Re: PIX translation I want to understand

ok so when this option is enabled you mean that traffic is only routed on each interfaces no acl are needed ? but it seems that i have to allow some traffic...

ok i will send to you the configuration

124
Views
0
Helpful
3
Replies