Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

PIX xlate timeout

Does anyone know if there is a way to associate different xlate timeout values with different global pools if I'm doing policy NAT?

So, if I NAT to one destination I can set the xlate timeout value to 4 hours and if I NAT to a second destination I can set the xlate timeout to 7 hours?

Thanks,

3 REPLIES

Re: PIX xlate timeout

Hello Jeff,

I really dont think you can do this !!! timeout xlate is a global command which applies to all the NAT translation entries.. you cannot set this parameter with a source IP address...

Hope this helps.. all the best.. rate replies if found useful..

Raj

New Member

Re: PIX xlate timeout

Jeff,

Timeout xlate is a global command

http://www.cisco.com/en/US/products/hw/switches/ps708/products_command_reference_chapter09186a008048f6fb.html#wp1259027

however you could user conn timeout under class-map/policy-map to achieve what you are aiming at.

New Member

Re: PIX xlate timeout

Looks like this isn't going to work for me as I'm using a PIX535 running 6.3.4 and the policy map/class map commands looks like they were introduced on the FWSM 3.1 code.

Thanks anyway.

482
Views
0
Helpful
3
Replies
CreatePlease to create content