Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Pix501 EasyVPN to Pix515 ver6.3.5 Multiple network issue

I have an easyvpn tunnel from a 501 to a 515. I have multiple vlans on layer 3 switch at 501 location. Is it possible to get all networks at remote branch to tunnel through easyvpn to 515 main site?

I am using split tunneling. I have added the second network in the access list permit statements on the 515. And no go. I have all routes at main location pointing back through the 515 for the second network as well.

networks

main:

10.90.x.x

remote

10.80.x.x

192.168.x.x

Thanks for the help

1 REPLY

Re: Pix501 EasyVPN to Pix515 ver6.3.5 Multiple network issue

if u have the remote site connect to the main site as easyVPN and want the main site to see the two LANs behind the remote site

first u need on the main site config to enable RRI reverse route injuction

and u need route in the remote pix configured to the lans on the switch

in the split tunnel as i see u need an ACL like

access-list 1 permit 10.90.x.x mask

on the main site and apply it to the client group config

good luck

if helpful Rate

112
Views
0
Helpful
1
Replies
CreatePlease login to create content